Inspection Chamber Blanking Plug - 110mm
This chamber base blanking plug can be used in any of our inspection chamber bases to blank off unused inlets.
The plug itself is pushed directly into the ring seal of the inlet to form a watertight seal.
Most chamber bases already come with the side inlets blanked off. This enables the installer to remove only the plugs that are required, leaving the unused inlets safely sealed.
Inspection Chamber Components
Whilst most customers generally order inspection chambers as sets (base, risers and cover) there are often occasions when it is easier to order the chamber in its individual components. This allows for greater flexibility on site, for example where the final drainage layout is likely to differ from that suggested in the plans, or where the finished ground levels are subject to change.
All of these components can be interchanged with the relevant chamber sets, so if you are simply looking for an additional riser then you are in the right place! Just make sure that the manufacturers of each are the same, as chamber bases and risers from different manufacturers are rarely interchangeable.
All of our inspection chamber components are sourced from reputable supplier partners who are leaders in the UK market such as ClarkDrain and FloPlast.
Inspection chambers are a vital part of the underground drainage system, whether it be residential or commercial. They are necessary to provide access into various key points of the underground drainage system. Such access points are used for maintenance tasks such as inspecting and testing pipes to ensure that effluent is flowing correctly and to clear any potential blockages with drain rods or high pressure jetting as required.