Solvent Weld Soil Access Branch - 92.5 Degree x 110mm Olive Grey

In stock
Code
SS503
More Information
Code SS503
EAN Code 5055149908149
Angle 92.5 Degree
Brand FloPlast
Colour Olive Grey
Material PVC-u
Guarantee 1 Year Manufacturer Performance Guarantee
Specification BS EN 1329-1:2000 / BS4514:2001
Size 110mm
£26.22 £21.85
You need to spend another £250.00 to qualify for 2.5% discount.

This branch incorporates an access point that allows the soil pipe to be rodded in either direction. it is often sited where at the point on the external wall where an internal soil pipe connects to the outside soil and vent pipe.

To use the access point, simply remove the cap by unscrewing it from the threaded projection on the fitting. This will release any blockage so it is always advisable to stand aside at this point!

All three connections are solvent sockets to connect to a plain ended pipe or to the spigot (plain end) of another fitting.

The circular waste bosses on either side of the branch can be drilled out and used in conjunction either with our SP10, SP11 and SP12 rubber boss adaptors or our SP20, SP21 & SP22 solvent boss adaptors to introduce a 32mm, 40mm or 50mm waste pipe into the soil stack.

This solvent weld PVC soil access branch is available in black and olive grey.

Solvent Weld Soil System

Our FloPlast solvent weld soil system is commonly used in both domestic and commercial installations. It has been rigorously tested by the British Standards Institute and holds the prestigious BS kitemark.

To make a solvent weld joint, ensure that the surfaces to be jointed are clean and free of swarf. Apply SC250 solvent cement to both the spigot and the socket, assemble the joint and give it a twist to ensure that full contact has been made. Clean off any excess solvent and allow 24 hours for the joint to cure.

Note – solvent weld joints are permanent and cannot be de-mounted once made.