Solvent Weld Soil Access Pipe - 110mm Olive Grey
|Guarantee||1 Year Manufacturer Performance Guarantee|
|Specification||BS EN 1329-1:2000 / BS4514:2001|
The purpose of this 110mm soil access pipe is to allow the soil pipe system to be inspected and cleared in the event of any blockage.
In domestic properties it is usually situated at the foot of the soil pipe at the point where it enters the drainage system. To use the access point, simply remove the access cap by unscrewing it from the threaded projection on the fitting. This could potentially release any blockage above the cap so it is always advisable to stand aside at this point!
This bend has a solvent socket on each end to connect to a plain ended pipe or to the spigot (plain end) of another fitting.
This solvent weld PVC soil access pipe is available in black and olive grey.
Solvent Weld Soil System
Our FloPlast solvent weld soil system is commonly used in both domestic and commercial installations. It has been rigorously tested by the British Standards Institute and holds the prestigious BS kitemark.
To make a solvent weld joint, ensure that the surfaces to be jointed are clean and free of swarf. Apply SC250 solvent cement to both the spigot and the socket, assemble the joint and give it a twist to ensure that full contact has been made. Clean off any excess solvent and allow 24 hours for the joint to cure.
Note – solvent weld joints are permanent and cannot be de-mounted once made.