Solvent Weld Soil Bend - 135 Degree x 110mm Olive Grey - OUT OF STOCK
|Guarantee||1 Year Manufacturer Performance Guarantee|
|Specification||BS EN 1329-1:2000 / BS4514:2001|
This 45 degree bend is used to change the direction of a PVC soil pipe. It is also sometimes referred to as a 135 degree bend. This fitting can be used in either a horizontal or vertical plane, and two bends together are sometimes used as a pair to create an offset within a pipe run.
This bend has a solvent socket on each end to connect to a plain ended pipe or to the spigot (plain end) of another fitting.
This solvent weld PVC soil bend is available in black and olive grey.
Solvent Weld Soil System
Our FloPlast solvent weld soil system is commonly used in both domestic and commercial installations. It has been rigorously tested by the British Standards Institute and holds the prestigious BS kitemark.
To make a solvent weld joint, ensure that the surfaces to be jointed are clean and free of swarf. Apply SC250 solvent cement to both the spigot and the socket, assemble the joint and give it a twist to ensure that full contact has been made. Clean off any excess solvent and allow 24 hours for the joint to cure.
Note – solvent weld joints are permanent and cannot be de-mounted once made.