Solvent Weld Soil Branch - 135 Degree x 110mm Black
|Guarantee||1 Year Manufacturer Performance Guarantee|
|Specification||BS EN 1329-1:2000 / BS4514:2001|
Used to bring horizontal and vertical pipe runs together, usually when connecting a pipe from a WC into the main soil stack. The 135 degree angle introduces a steeper fall to the horizontal run than a standard 92.5 or 112.5 degree branch. It is most commonly found on the outside wall of a building, often on blocks of flats or apartments.
All three connections are solvent sockets to connect to a plain ended pipe or to the spigot (plain end) of another fitting.
The two circular waste bosses on either side of the branch can be drilled out and used in conjunction either with our SP10, SP11 and SP12 rubber boss adaptors or our SP20, SP21 & SP22 solvent boss adaptors to introduce a 32mm, 40mm or 50mm waste pipe into the soil stack.
This solvent weld PVC soil branch is available in black and olive grey.
Solvent Weld Soil System
Our FloPlast solvent weld soil system is commonly used in both domestic and commercial installations. It has been rigorously tested by the British Standards Institute and holds the prestigious BS kitemark.
To make a solvent weld joint, ensure that the surfaces to be jointed are clean and free of swarf. Apply SC250 solvent cement to both the spigot and the socket, assemble the joint and give it a twist to ensure that full contact has been made. Clean off any excess solvent and allow 24 hours for the joint to cure.
Note – solvent weld joints are permanent and cannot be de-mounted once made.