FloPlast Solvent Weld Waste Bend Swept - 92.5 Degree x 50mm White

In stock
Only %1 left
Code
WS16

Click or tap the image to open in fullscreen

FloPlast Solvent Weld Waste Bend Swept - 92.5 Degree x 50mm White
FloPlast Solvent Weld Waste Bend Swept - 92.5 Degree x 50mm White
From 2 reviews
More Information
Code WS16
£2.66 £2.22 £0.90
Spend another £1500 to pay over time with Klarna

Swept bends are used to create a 92.5 degree change of direction in a waste pipe system. They have a longer radius than knuckle bends and the 92.5 degree angle promotes a self-cleansing flow.

This fitting is available in 32mm, 40mm and 50mm size options.

Our solvent weld waste is manufactured in the UK to BS EN 1455 and is kitemarked.

To make a solvent weld joint, first ensure that the outer wall of the pipe and the inner wall of the fitting are both clean and free from grit or swarf. Apply SC250 solvent cement to both surfaces. Push the pipe fully into the fitting and give it a twist to ensure that full contact has been made. Clean off any excess solvent with a damp cloth and leave for 5 minutes to set. The installation should be left for 12 hours before testing.

Click here to watch a step by step video of how to make a solvent weld joint.

Solvent weld joints are permanent - they cannot be demounted once the joint has been made. When using solvent cement, always work in a well ventilated area and keep the cement away from heat sources or naked flames. Avoid any contact with skin - if contact does occur then wash thoroughly with soap and water.

YOU MAY ALSO LIKE