What Are Push Fit Fittings?

WHAT DOES PUSH-FIT MEAN?

Traditional fittings are often replaced with push-fit fittings. They don't require any special tools and are considerably easier to install than other types of fittings. Simply insert the pipe into the fitting to form a watertight seal.

They are available in several configurations (typically plastic and copper), may be used in a variety of applications, and have several advantages.

HOW DOES PUSH-FIT WORK?

Push-fit connectors typically have an 'O'-ring seal and a metal-toothed grab ring to secure the pipe and produce a watertight seal.

It's the same sort of connector you'd find on a power washer's hose, or the compressor-driven equipment technicians use while working on your car. Those fittings must be able to endure hundreds of pounds of pressure over long periods.

Due to their adaptability, push-fit fittings tend to be used in renovations, or under temporary circumstances, such as fixing a leaking pipe.

Click here to find out how to install push-fit fittings.

ARE PUSH-FIT PIPES ANY GOOD?

The quality of the internal components is equally as crucial as the fitting body. For excellent corrosion resistance, push-fit fittings employ high-grade materials such as the stainless-steel gripper ring. Additionally, the EPDN O-ring is long-lasting and is lubricated with silicone grease.

They are suitable for the following environments:

  • Potable water, plumbing, water heaters, and hydronic heating systems, in both residential and commercial applications.
  • Can be used in new and dry repairs to existing plumbing.
  • Can be used in wet repairs if a system is difficult to drain and no drying time is necessary.
  • Ideal for use in hazardous areas because no heat or flame is required for installation, they are ideal for fire-prone repairs.
  • Appropriate for use underground and behind walls, with or without access panels.

WHAT IS THE DIFFERENCE BETWEEN PRESS-FIT AND PUSH-FIT?

Unlike press-fit systems, they do not require any additional equipment to install. After the pipes have been cut, measured, and deburred, the actual jointing takes only seconds to accomplish.