Push Fit Waste Bend - 135 Degree x 32mm Black

In stock
Code
WP18B

Click or tap the image to open in fullscreen

Push Fit Waste Bend - 135 Degree x 32mm Black
Push Fit Waste Bend - 135 Degree x 32mm Black
From 1 reviews
More Information
Code WP18B
£1.93 £1.61 £1.93

135 degree bends, or 45 degree bends as they are sometimes called, are used to create a change of direction in a waste pipe system. Two bends are often used together to create an offset in the pipe run.

This fitting is available in 32mm, 40mm and 50mm size options, with 50mm only available in grey.

This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.

When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.

Click here to read our guide that explains the key differences between push fit and solvent weld waste systems.