Push Fit Waste Bend Knuckle - 90 Degree x 32mm Black
- Buy 1000000 for £1.08 £0.90 each and save 9%
Code | WP10B |
---|---|
EAN Code | 5055149903250 |
Weight (kg) | 0.170000 |
Angle | 90 Degree |
Brand | FloPlast |
Colour | Black |
Material | Polypropylene |
Pack Size | Single |
Style | Knuckle |
Guarantee | 1 Year Manufacturer Performance Guarantee |
Specification | BS EN 1451-1:2000/BS 5254 1976 |
Size | 32mm |
Knuckle bends are used to create tight, neat 90 degree bends in a waste pipe system. They have a tighter radius than the standard swept bends.
This fitting is available in 32mm, 40mm and 50mm size options, with 50mm only available in grey.
This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.
When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.
Push Fit Waste System
Push fit waste pipe and fittings are very popular with all types of installer as unlike solvent weld systems the joints are not permanent, they can be demounted and re-made at any time.
The watertight seal in push fit waste systems are created by an O ring seal. When the pipe is introduced into the fitting, the seal is compressed between the outside wall of the pipe and the inner wall of the fitting, creating a barrier that water cannot pass through.
Our push fit pipes and fittings are made from durable polypropylene. They are manufactured in the UK by FloPlast, one of Europe’s leading suppliers of all types of gutter, soil, waste and underground drainage products.
Choose from the three colour options in our extensive range, white, black or grey.