Push Fit Waste Bend Swivel - 90 Degree x 32mm Grey
|Guarantee||1 Year Manufacturer Performance Guarantee|
|Specification||BS EN 1451-1:2000/BS 5254 1976|
Swivel bends are used to create a tight radius 90 degree change of direction in a waste pipe system. They are also often referred to as M and F bends or spigot bends. They have a long tail that is usually inserted into the socket of another fitting.
This fitting is available in 32mm and 40mm size options.
This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.
When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.
Push Fit Waste System
Push fit waste pipe and fittings are very popular with all types of installer as unlike solvent weld systems the joints are not permanent, they can be demounted and re-made at any time.
The watertight seal in push fit waste systems are created by an O ring seal. When the pipe is introduced into the fitting, the seal is compressed between the outside wall of the pipe and the inner wall of the fitting, creating a barrier that water cannot pass through.
Our push fit pipes and fittings are made from durable polypropylene. They are manufactured in the UK by FloPlast, one of Europe’s leading suppliers of all types of gutter, soil, waste and underground drainage products.
Choose from the three colour options in our extensive range, white, black or grey.