Push Fit Waste Reducer - 40mm x 32mm White

In stock
Code
WP38
From 1 reviews
More Information
Code WP38
EAN Code 5055149903601
Brand FloPlast
Colour White
Material Polypropylene
Guarantee 1 Year Manufacturer Performance Guarantee
Specification BS EN 1451-1:2000/BS 5254 1976
Size 40mm x 32mm
£1.30 £1.08
You need to spend another £250.00 to qualify for 2.5% discount.

This waste reducer is used when a 32mm waste pipe is connected into a 40mm pipe, usually with the 32mm pipe dropping into the 40mm pipe below it running towards the soil pipe.

It is usually used in the branch of a 40mm tee or in one end of a 40mm coupling.

This push fit waste system is manufactured in the UK to BS EN 1451 and is British Standard kitemarked.

When making a push fit joint, cut the pipe square and remove any burrs, push the pipe into the fitting as far as it will go and then withdraw it by approximately 10mm to allow for any expansion. The joint can be taken apart again if required, but always check that the O ring has not been dislodged from its housing groove in the fitting as this will cause the joint to leak.

Click here to read our guide that explains the key differences between push fit and solvent weld waste systems.

Push Fit Waste System

Push fit waste pipe and fittings are very popular with all types of installer as unlike solvent weld systems the joints are not permanent, they can be demounted and re-made at any time.

The watertight seal in push fit waste systems are created by an O ring seal. When the pipe is introduced into the fitting, the seal is compressed between the outside wall of the pipe and the inner wall of the fitting, creating a barrier that water cannot pass through. 

Our push fit pipes and fittings are made from durable polypropylene. They are manufactured in the UK by FloPlast, one of Europe’s leading suppliers of all types of gutter, soil, waste and underground drainage products.

Choose from the three colour options in our extensive range, white, black or grey.